Taylor-Dunn ET-3000 Manual page 106

Transmission
12. Remove the circlip from the idler gear.
13. Remove the input shaft/bearing assembly and idler gear/
bearing assembly from the gear case cover at the same
time.
14. Remove the pinion nut from the output gear and remove
the output gear from the pinion shaft.
Note: If necessary, remove the seal
15. Mark the gear case position in relation to the 3rd member
housing so that it will be reassembled in the same position.
16. Remove the six retaining bolts holding the gear case to the
3rd member housing.
Note: Make note of the angle of the
17. Remove the gear case housing from the 3rd member
housing.
18. Inspect all parts for signs of wear or damage.
Page 2
from the input shaft bore at this
time.
gear case.
T-48 AC / ET 3000
MB-T48-02