Commissioning; Note Before Initial Start Up - Siemens SIMATIC HMI IPC577C Operating Instructions Manual

Commissioning

8.1

Note before initial start up

Check list
Before starting up the device for the first time, go through the following checklist:
● Have you taken into account the proper ambient and environmental conditions for the
● Have you connected the equipotential bonding if required?
● Have you checked that the power supply is connected correctly and that the values are
● Read over this information in the chapter Connecting (Page 45) of the operating
Delivery state
The following operating systems are available for the IPC577C:
● Windows Embedded Standard 2009 is pre-installed on CompactFlash card, or SSD, or
● Windows XP Professional (32-bit) pre-installed on SSD or hard disk
● Windows Embedded Standard 7 pre-installed on CompactFlash card, or SSD, or hard
● Windows 7 Ultimate (32-bit) pre-installed on SSD or hard disk
SIMATIC HMI IPC577C
Operating Instructions, 10/2010, A5E02368074-02
device, as described in the specifications?
appropriate?
instructions. Please follow all guidelines.
CAUTION
Condensation
When transporting the device at low temperatures, ensure that no moisture gets on or
into the device. This also applies if the device is subjected to extreme changes in
temperature. Wait 12 hours before switching the device on.
Allow the device to slowly adjust to room temperature before commissioning the device.
Do not subject the device to direct heat radiation from devices such as heaters.
NOTICE
Windows Embedded Standard 2009 and Windows Embedded Standard 7: Observe the
EWF rules
A configurable write filter (Enhanced Write Filter) is made available for Windows
Embedded Standard 2009 and Windows Embedded Standard 7. Please observe the
EWF rules during commissioning, since a data loss may otherwise occur.
hard disk
disk
8
55