Maintenance and Service
12.2 Removing and installing hardware components
Replacing the battery of the IPC577C
Steps for replacing the battery
1. Open the device as described in section Open the device. (Page 89).
2. Pull the battery plug
3. Remove the battery from the bay.
4. Install the new battery and plug in the battery plug.
5. Close the device.
Reconfiguring the BIOS setup
When a battery is exchanged, the configuration data of the device are lost and must be
reentered in the BIOS setup.
12.2.3
Installation/removal of SSD
Only qualified technical personnel are permitted to replace an SSD.
Tools
You need a TORX T10 screwdriver to carry out the mounting work.
You will need a TORX T20 screwdriver to loosen the equipotential bonding terminal.
Preparatory steps
1. Disconnect the device from the power supply.
2. Unplug all peripherals (mouse, keyboard, external monitor, for example) from the device.
102
①
.
CAUTION
SIMATIC HMI IPC577C
Operating Instructions, 10/2010, A5E02368074-02