Table of Contents
Advertisement
12.2.4
Installation/removal of hard disk drive
Only qualified technical personnel are permitted to replace a hard disk.
Tools
You need a TORX T10 screwdriver to carry out the mounting work.
You will need a TORX T20 screwdriver to loosen the equipotential bonding terminal.
Preparatory steps
1. Disconnect the device from the power supply.
2. Unplug all peripherals (mouse, keyboard, external monitor, for example) from the device.
Removing the hard disk
NOTICE
Note the ESB instructions.
Steps for removing the hard disk
1.
2.
SIMATIC HMI IPC577C
Operating Instructions, 10/2010, A5E02368074-02
CAUTION
Open the device as described in section Open the device. (Page 89).
②
Pull the plug
from the socket and remove
①
the cable ties
.
12.2 Removing and installing hardware components
Maintenance and Service
105
Advertisement
Table of Contents
