Commissioning Windows Embedded Standard; Basic Commissioning - Initial Startup - Siemens SIMATIC HMI IPC577C Operating Instructions Manual

Commissioning

8.2 Commissioning Windows Embedded Standard

8.2 Commissioning Windows Embedded Standard
8.2.1

Basic commissioning - initial startup

Requirement
● The device is connected to the power supply.
● The equipotential bonding is connected.
● The cables are correctly plugged in.
Setting up the operating system
Note
Initial commissioning of Windows Embedded Standard 2009
System startup can take longer than usual for the initial commissioning. Only a blue screen
is displayed for several minutes.
The devices with Touch Panel require a USB mouse for commissioning.
On completion of the initial startup of the computer, the operating system on the
CompactFlash card, or Solid State Drive (SSD), or hard disk is set up automatically on the
computer.
Proceed as follows:
1. Switch the device on using the On/Off switch. The PC performs a self-test (POST).
2. Wait until this message is cleared, then follow the instructions on the screen.
3. Restart
Note
System startup can take longer than usual for the initial commissioning. The screen will
display "FBResseal Resealing in progress..." for several minutes.
56
During the self-test, this message appears:
Press <F2> to enter SETUP or <ESC> to show the boot menu
NOTICE
The device may not be switched off at any time during the installation process.
Do not change the default BIOS settings, otherwise the operating system setup may
become corrupted.
After you have entered all the necessary information and the operating system is
configured,
you are prompted to restart the system. Acknowledge this prompt with Yes.
SIMATIC HMI IPC577C
Operating Instructions, 10/2010, A5E02368074-02