Step 7: Connecting The Cables - Roland TrueVIS SG3-540 Setup Manual

Hide thumbs Also See for TrueVIS SG3-540:
Table of Contents

Advertisement

1. Assembly and Ink Filling

Step 7: Connecting the Cables

WARNING
Perform this task with all power switches left switched off.
Otherwise sudden movement of the machine may cause injury.
WARNING
Connect to an electrical outlet that complies with this machine's ratings (for voltage, frequency,
and current).
Incorrect voltage or insufficient current may cause fire or electrical shock.
WARNING
Handle the power cord, plug, and electrical outlet correctly and with care. Never use any article
that is damaged.
Using a damaged article may result in fire or electrical shock.
WARNING
When using an extension cord or power strip, use one that adequately satisfies the machine's rat-
ings (for voltage, frequency, and current).
Use of multiple electrical loads on a single electrical outlet or of a lengthy extension cord may cause fire.
Procedure
1.
Connect both the power cord and the Ethernet cable (commercially available).
• The recommended Ethernet and Ethernet cable are as follows.
• Ethernet: 1000BASE-T
• Ethernet cable: Category 5 or higher
• Use a power plug connector if the electrical outlet is a two-prong outlet.
WARNING
Connect this machine to a power outlet. Never connect this machine directly to a power
distribution panel or other such fixed wiring equipment.
Doing so increases the risk of fire or electrical shock.
WARNING
Connect to ground.
This can prevent fire or electrical shock due to current leakage in the event of malfunction.
2.
Use clamps to secure the power cord and Ethernet cable.
34
Installation

Advertisement

Table of Contents
loading

This manual is also suitable for:

Truevis sg3-300

Table of Contents