Step 2: Attaching The Printer Unit And The Stand - Roland TrueVIS SG3-540 Setup Manual

Step 2: Attaching the Printer Unit and the Stand

Procedure
1.
With six or more workers, lift up the printer unit.
CAUTION
Unpacking and installation must be carried out by 6 persons or more.
Failure to observe this instruction may cause the machine to fall over, resulting in injury.
2.
Move the stand under the printer unit.
The stand must be moved by a worker other than those indicated in step 1.
3.
Align the printer unit and the stand.
IMPORTANT
There is a protrusion (A) on the tabletop plate. Inserting this protrusion into the slit (B) on the printer unit
allows for alignment to the front, back, left, and right. After aligning these items, place the printer unit on
the stand.
(1)
Align the surface of the printer unit (A) and the vertical line of the triangle mark (B) on the stand as
seen from the rear of the printer. (Align the left and right sides.)
1. Assembly and Ink Filling
Installation
13