Step 6: Removing The Retainers - Roland TrueVIS SG3-540 Setup Manual

Step 6: Removing the Retainers

IMPORTANT
• Make sure to remove all the retainers. Any that remain may cause faulty operation or breakdown when the power is
switched on.
• Store the retainers because they are needed again when transporting the machine.
Procedure
1.
Open the front cover.
2.
Remove all the retainers.
3.
Install the retainer indicated by C at the position indicated in the figure for storage.
Use the bolt removed in step 2.
4.
Close the front cover.
1. Assembly and Ink Filling
Installation
33