Inserting And Specifying An Ac Power Module - Siemens SINAMICS S120 Commissioning Manual

8. Confirm the procedure with "Yes".
The Motor Module selection list is now refreshed.
9. Select the Motor Module based on the Article No.
The data of the selected Motor Module is assigned to the Motor Module in the device
configuration. The Motor Module has therefore been specified.
The corresponding component is shown in the device configuration in dark gray.
5.3.6.2

Inserting and specifying an AC Power Module

Overview
Depending on the drive type, when creating an AC Power Module, either drive object type
"Highly dynamic (servo)" or "Universal (vector)" is active as default. Many of the following
settings depend on the drive object type that has been set.
Requirement
• A SINAMICS S120 Control Unit has been inserted in the device configuration.
Restrictions
• Only chassis format AC Power Modules can be specified in the Startdrive engineering tool.
Commissioning with Startdrive
Commissioning Manual, 06/2020, 6SL3097-5AA10-0BP2
Commissioning
5.3 Creating a project offline
125