Drill Master XP User Manual page 8

5. Service
a) Have your tool serviced by a qualified repair person using only identical
replacement parts. This will ensure that the safety of the power tool is
maintained.
For Service Contact:
Darex, LLC
PO Box 730
210 E Hersey St.
Ashland, OR 97520
USA
Phone: (800) 597-6170
Fax: (541) 552-1377
Email: techsupport2@darex.com
Specific Safety Rules
WARNING! ALWAYS use proper safety glasses. Everyday eyeglasses are
NOT safety glasses. Also use face of dust mask if operation is dusty. ALWAYS
wear certified safety equipment:
• ANSI Z87.1 eye protections (CAN/CSA Z94.3)
• ANSI 512.6 (53.19) hearing protection
• NIO5H/OSHA respiratory protection
WARNING! Use of this tool can generate and/or disperse dust, which may
cause serious permanent respiratory or other injury. Always use NIOSH/OSHA
approved respiratory protection appropriate for the dust exposure. Direct
particles away from face and body.
WARNING! This product contains a chemical known to the State of
California to cause cancer. Some dust created by power sanding and grinding
as well as contents from the machine may contain chemicals known to the State
of California to cause cancer, birth defects or other reproductive harm.
WARNING! Avoid prolonged contact with dust from power sanding,
sawing, grinding, drilling, and other construction activities. Wear protective
clothing and wash exposed areas with soap and water. Allowing dust to get
into your mouth, eyes, or lie on the skin may promote absorption of harmful
chemicals.
Motor
Be sure your power supply agrees with the nameplate marking. 120 Volts AC
only means your tool will operate on standard 60 HZ household power. Do not
operate AC tolls on DC. A rating of 120 volts AC/DC means that your tool will
operate on standard 60 Hz AC or DC power. This information is printed on the
nameplate. Lower voltage will cause loss of power and can result in
over-heating.
6
www.drilldoctor.com