Drill Master XP User Manual page 7

operate the power tool. Power tools are dangerous in the hands of
untrained users.
g) Maintain power tools. Check for misalignment or binding of moving
parts, breakage of parts and any other condition that may affect the
power tool's operation. If damaged, have the power tool repaired
before use. Keep unit dry, clean and free from oil and grease. Many
accidents are caused by poorly maintained power tools.
h) CAUTION! Keep power tools and work space clean for best
performance and safety. Do not let sharpening debris accumulate on,
in, or around the tool. Accumulated fine metal Sharpening debris can
be very hot and may present a fire danger if the machine or your
workspace is not properly cleaned and maintained. Accumulated
sharpening debris can also degrade the life of the tool and cause
premature wear on some components. If sharpening debris has
accumulated, do not immediately throw it into a trash receptacle
without ensuring the debris is completely cool and free of heat.
Improperly disposing of the accumulated sharpening debris may
present a fire risk. Do not collect the sharpening debris during
sharpening. This increases the risk of heat build-up in the debris and
the potential for fire.
i) Keep guards in place and in working order. A guard or other part that
is damaged should be properly repaired or replaced by an authorized
service center unless otherwise indicated in the instruction manual.
j) Never stand on the power tool. Serious injury could occur if the tool is
tipped or if the sharpening edge is unintentionally contacted.
WARNING! Use recommended accessories. Use the power tool,
k)
accessories, abrasives, and tool bits etc., in accordance with these
instructions, taking into account the working conditions and the work
to be performed. Use of the power tool for operations different from
those intended could result in a hazardous situation.
l) Check damaged parts. Before further use of the tool, a guard or other
part that is damaged should be carefully checked to determine that it
will operate properly and perform its intended function. Check for
alignment of moving parts, binding of moving parts, breakage of parts,
mounting and any other conditions that may affect its operation. A
guard or other part that is damaged should be properly repaired or
replaced by an authorized service center unless otherwise indicated in
the instruction manual. Have defective switches replaced by an
authorized service center. Do not use the tool if the switch does not
turn it on and off. Do not use if the grinding wheel is damaged. Use
only grinding wheels recommended by Drill Doctor®
www.drilldoctor.com
5