Table of Contents
Advertisement
Available languages
Available languages
2.
+
3.
www.drilldoctor.com
Insert Chuck into
Alignment Port and
adjust bit poisiton
To adjust the Chisel and
Relief Angles, simply align
the bit as usual with the fol-
lowing adjustment;
To increase Relief—position
the Chuck in the Alignment
Port so that the Alignment
Guide is closer to the (+)
position. This will make a
more aggressive drill point.
To decrease Chisel and
Relief—position the Chuck in
the Alignment Port so that
the Alignment Guide is closer
to the (-) position. This will
make a more precise hole.
Take care not to adjust Relief
–
118˚
Tighten Chuck, and
sharpen as usual
Refer to page 14 for these
Steps. Experiment with a few
different settings to find the
one that best suits your drill
bits and application. You may
find it helpful to mark this
setting for future use.
too far as this will actually
cause the drill to lose all
Relief and therefore
not drill a hole.
Each notch in the
Alignment Port is
approximately a 10˚
change
Angle.
in
Chisel
23
Advertisement
Chapters
Table of Contents
