Drill Master XP User Manual page 15

3.
4.
5.
www.drilldoctor.com
Adjust Bit Position
Look at your bit and make
sure the Bit Clamp Arms are
in the bit's narrowest spot. If
they aren't, turn the bit in the
chuck so that it is held by the
Bit Clamp Arms at its narrow-
est width. This is important
because this setting deter-
mines the angle at which your
bit will be sharpened.
Bit Clamp Arms
Drill Stop
Tighten Chuck
Hold onto the Chuck and
tighten the Chuck Knob.
(Avoid over-tightening the
Chuck in the Alignment Port.
This could damage the Chuck
and Port.)
Remove and re-tighten
Press the Alignment Button
and remove the chuck from
the Alignment Port. Tighten
the Chuck once more to
ensure the bit won't move
when you sharpen it.
You are now ready to sharpen
the drill bit.
13