Drill Master XP User Manual page 29

9. Question:
Why does the drill bit back up into the Chuck during
the sharpening procedure?
Answer:
Make sure the bit is tight in the Chuck before sharpening.
Your Chuck may be dirty. Follow the steps for cleaning the
Chuck on page 28.
10. Question:
When splitting, why don't I hear a grinding sound?
Answer:
The Chuck is not seated properly in the Splitting Port. The
Chuck's Sharpening Guide must line up with the Splitting
Guide on the top of the Split Point Port. Firmly and slowly
push the Chuck into the hole until the grinding sound stops.
11. Question:
Can I change a 135° drill bit into a 118° drill bit?
Answer:
You can change the degree angle of any drill bit from 135°
to 118°. The alignment and sharpening procedure will
need to be performed three or more times to remove the
old angle and produce the new angle desired. If you
change a 135° angle to a 118° angle you will not be able to
return to a 135° angle using this machine.
27
www.drilldoctor.com