Siemens SIMATIC ET 200SP Manual page 31

Configuring/address space
4.1 Operating with "Counting and measurement" technology object
Reaction to violation of a count-
ing limit
Reset when counting limit is
violated
Reaction to gate start
Set function of DI
Input delay for digital inputs
Edge selection for DI
Select level for DI
Behavior of counter value after
Capture with DI
Comparison value 0
Comparison value 1
Operating mode
30
Parameter
•
•
•
•
•
•
•
•
•
•
•
•
•
•
•
•
•
•
•
•
•
•
•
•
•
•
•
•
•
-2147483648...0...2147483647
-2147483648...10...2147483647
•
•
Value range
Stop counting
Continue counting
To opposite counting limit
To start value
Set to start value
Continue with current value
Gate start/stop (level-triggered)
Gate start (edge-triggered)
Gate stop (edge-triggered)
Synchronization
Enable synchronization at signal N
Capture
Digital input without function
None
0.05 ms
0.1 ms
0.4 ms
0.8 ms
1.6 ms
3.2 ms
12.8 ms
20 ms
At rising edge
At falling edge
At rising and falling edge
Active with high level
Active with low level
Continue counting
Set to start value and continue counting
Use count value as reference
Use measured value as reference
TM Count 1x24V (6ES7138‑6AA01‑0BA0) technology module
Scope
Channel
Channel
Channel
Channel
Channel
Channel
Channel
Channel
Channel
Channel
Channel
Manual, 07/2019, A5E33002339-AD