Checking After Installation; Operation Check - Canon imageRUNNER ADVANCE C2030 Service Manual

20) Remove the release paper from the Cord Guides, and affix the guides to the 6 areas
indicated in the figure.
21) Put the DVI Cable through the Cord Guides, and install the covers of the guides.
x6
NOTE:
In the case of simultaneous installation with the Card Reader-C1, do not
install the Cord Guide to the [A] part because the Wire Saddle (included
in the package of the Card Reader) needs to be installed.
x6
9
Installation > Voice Operation Kit-C2 > Operation Check > When Stopping to Use
F-9-168
[A]
F-9-169
9 Installation > Voice Operation Kit-C2 > Operation Check > When Stopping to Use

Checking after Installation

NOTE:
When changing the settings upon user's request, it is required to log in as a system
manager in accordance with instructions from the user administrator.
1) Connect the power plug of the host machine to the outlet.
2) Turn ON the main power switch.
3) Select Settings/Registration > Preferences > Accessibility > Voice Navigation Settings >
Use Voice Navigation, and check that the setting is ON.
4) Select Settings/Registration > Preferences > Accessibility > Voice Navigation Settings >
Voice Navigation at Startup, and check that "Select Mode at Startup" is set.
5) Select Settings/Registration > Preferences > Accessibility > Voice Navigation Settings, and
check that "Tune Microphone" is displayed.
6) To make the setting value effective, turn OFF/ON the main power of the Host Machine.

Operation Check

■ When Starting to Use
1) Press "Reset" key or the Voice Recognition button for more than 3 seconds.
2) In "Select the Voice Navigation type." on the Control Panel screen, select "Manual + Vocal
Mode", "Vocal Mode" or "Manual Mode", and press OK.
3) Once the indication on the screen is framed in red, the "Voice Operation Kit" becomes
enabled.
NOTE:
When "Manual Mode" is selected in "Select the Voice Navigation type.", nothing
happens by pressing the Voice Recognition button.
■ When Stopping to Use
1) Press "Reset" key or the Voice Recognition button for more than 3 seconds.
9-74
9-74