Basic Flowchart - Canon imageRUNNER ADVANCE C2030 Service Manual

Basic Flowchart

Basic Check Items
Check all of the items shown below.
Turn O N the m ain power s witc h.
Does the Pow er Supply LED
on the Control Panel light up?
Yes
Is the Control Panel dis play ed?
Yes
Does the main body boot c orrec tly ?
Yes
Take an ac tion appropriate f or
the error.
6
Troubleshooting > Controller Self Diagnosis > Basic Flowchart > Prerequisite
No
Ex ec ute bas ic c hec k.
No
Ex ec ute Boot Sy s tem Error
Diagnos is Tool.
No
Ex ec ute Controller Sy s tem Error
Diagnos is Tool.
F-6-146
6 Troubleshooting > Controller Self Diagnosis > Basic Flowchart > Prerequisite
■ Basic Check Items
1. Check if the Power Supply Plug is disconnected.
2. Check if the Connection Cable between the Main Controller PCB 1 and Control Panel is
disconnected.
3. Check if the Connection An All-night Power Supply. Check if the Connection Cable from
Main Controller PCB 2 is disconnected. Change AC Driver PCB if not recovered.
■ Prerequisite
This machine's Firmware is intalled in Flash PCB.
Controller System Error Diagnosis Tool (BCT) is also installed at the same time when System
software is installed.
NOTE:
BCT stands for Box Checker Test.
When BCT is installed on the main body, version of the installed module can be
checked using service mode (COPIER > DISPLAY > VERSION > BCT).
6-113
6-113