Table of Contents
Advertisement
#SMTPSENDMAILi – Send Mail without Interactive Mode
Description:
This command sends one of the 3 pre-defined email combinations. Once an IP link is
established, the attached host can direct the TCP/IP stack to send an email message at
anytime (except when the TCP/IP stack software is already using TCP resources). This
email's header is built using the REC1/2/3, CCREC1/2/3 and SUBJ1/2/3 parameters
while the body is filled in the BODY1/2/3 parameter. This command is similar to a "send
email" operation issued by a standard messaging client on a PC.
Syntax:
Set Value: AT#SMTPSENDMAILi (replace i with 1, 2, or 3)
Values:
REC1 or REC2 or REC3
CCREC1 or CCREC2 or CCREC3
SUBJ1 or SUBJ2 or SUBJ3
BODY1 or BODY2 or BODY3
SENDERADDR
SENDERNAME
DOMAIN
SMTPPORT
SMTPSERV
SMTPPW
SMTPUN
Default
Value: None
#SMTPPUTMAIL – Send Mail to Recipient 1 and CC 1
Description:
This command allows the attached host to send an email message passed to the TCP/IP
stack over the serial port and requests the message body to be entered. After entering
the message, type Ctrl+D to end the message and send the email.
Once an IP link is established, the attached host can send the email message at anytime
(except when the TCP/IP stack software is already using TCP resources). The header of
this email is built using the REC1, CCREC1 and SUBJ1 parameters. This command is
similar to a "send email" operation issued by a standard messaging client on a PC.
Syntax:
Set Value: AT#SMTPPUTMAIL
Values:
REC1
CCREC1
SUBJ1
SENDERADDR
SENDERNAME
DOMAIN
SMTPPORT
SMTPSERV
SMTPPW
SMTPUN
Default
Value: None
#SMTPPUTMAIL -B – Send Mail to Recipient 1 and CC 1 with
Description:
This command is used to send mail with MIME Encoded Binary attachments. The SMTP
session enters into interactive mode requesting the message body to be entered. After
entering the message, type Ctrl+D to end the message. The SMTP session then enters
into interactive mode requesting media-type, media-subtype, file name, file size and the
attachment body. When the attachment body reaches the file size, another message
displays asking whether to continue with one or more attachments. Type 'Y' for more
attachments and type 'N' to send mail. Then the email with its attachment is sent to the
to-addresses and cc-addresses configured.
Syntax:
Set Value: AT#SMTPPUTMAIL -B
Values:
None
Multi-Tech Systems, Inc. AT Commands for the MT800SWM & MTS2WFA (S000425D)
Interactive Mode
Chapter 4 – SMTP Commands
18
Advertisement
Table of Contents
