Table of Contents
Advertisement
#RESET – Restart the Module
Description:
Restarts our module from the command prompt.
Syntax:
Set Value: AT#RESET
Values:
None
Default
Value: None
E – Turn Echo ON/OFF
Description:
Use this command to turn ON/OFF echoing command at the serial terminal.
Syntax:
Set Value: ATE
Values:
No parameter values.
Default
Value: None
S2 – Escape Sequence
Description:
Use this command to change the character for escape sequence.
Syntax:
Set Value: ATS2=<+>
Values:
'c' value, which is used as the escape sequence
Default:
'+'
#WATCHDOG – Enable/Disable Watchdog
Description:
Enable/disable Watchdog for the system – reset on HANG.
Syntax:
Set Value: AT#WATCHDOG
View Value: AT#WATCHDOG?
Values:
0: Disable Watchdog
1: Enable Watchdog
Default
Value: 1: Enable Watchdog
#WATCHDOGTIMER – Watchdog Timer
Description:
Sets the Watchdog timer in milliseconds.
Syntax:
Set Value: AT#WATCHDOGTIMER
View Value: AT#WATCHDOGTIMER?
Values:
Maximum milliseconds that can be entered is 7000
Default
Value: 1000ms
#BOOTMSG – Enable/Disable Boot Message
Description:
Enables/disables the boot message.
Syntax:
Set Value: AT#BOOTMSG
View Value: AT#BOOTMSG?
Values:
0
1
Default:
1
Multi-Tech Systems, Inc. AT Commands for the MT800SWM & MTS2WFA (S000425D)
Disable
Enable
Enable
Chapter 9 – Miscellaneous Commands
35
Advertisement
Table of Contents
