Engine Air Intake Inspection; Pvt Air Intake Inspection - Polaris RANGER 500 2018 Service Manual

Hide thumbs Also See for RANGER 500 2018:

Table of Contents

2. Unhook the two clips

remove cover. Inspect the cover seal. It should

adhere tightly to the cover.

3. Remove the air filter assembly. Inspect the air filter

and replace if necessary.

If the filter has been soaked with fuel or oil it must be

replaced. Do not attempt to wash the air filter. If

cleaning is required, replace the filter.

Installation

9928485 R01 - 2017-2018 RANGER 500 / 570 Service Manual

from airbox cover and

4. Clean airbox of any oil or water deposits and apply a

5. Reinstall the air filter into the airbox container. Be

ENGINE AIR INTAKE INSPECTION

1. Remove the cover from the outer side of the seat

2. If the pre-filter element is dirty, clean it with hot,

3. Reinstall the pre-filter element into the seat frame

1. Remove the PVT intake cover

2. Verify there is no debris obstructing the airway.

3. Reinstall the cover.

small amount of grease to the sealing surfaces of the

sure the filter fits tightly in the air box and engage the

and remove the pre-filter element.

soapy water. Rinse and dry the filter element

thoroughly. Inspect element for tears or damage.

Replace if necessary.

and install the cover.

Table of Contents