Installing The Front Usb Connectors - IBM System x3610 Problem Determination And Service Manual

6. Remove the screws that secure the front USB connectors to the DVD drive
7. Disconnect the USB cables from the system board and remove them from the
8. Lift the USB connectors off the CD/DVD drive cage assembly.
9. If you are instructed to return the USB connector assembly, follow all packaging

Installing the front USB connectors

To install the replacement front USB connectors, complete the following steps.
1. Align the front USB connectors with the opening in the flange on top of the DVD
2. Attach the screws that secure the front USB connectors to the DVD drive cage
3. Place the cables through the clips that are on top of the DVD drive cage
4. Install the DVD drive cage assembly into the server.
5. Install the fan-bracket assembly (see "Installing the fan-bracket assembly" on
6. Route the USB cables in front of the fans and connect them to the system
7. Install the cover (see "Installing the cover" on page 46).
8. Slide the server into the rack and tighten the rack release thumbscrews.
64
IBM System x3610 Type 7942: Problem Determination and Service Guide
cage assembly.
clips that are on top of the DVD drive cage assembly.
instructions, and use any packaging materials for shipping that are supplied to
you.
drive cage assembly.
assembly.
assembly
a. Lower the drive-cage enclosure into the server; then, slide the enclosure
toward the front of the server until it is flush with the front of the chassis.
b. Replace the screws that secure the drive-cage enclosure to the chassis.
page 68).
board. See "System-board internal cable connectors" on page 9 for the
connector location.