Installing The Front Usb Connector Assembly - IBM System x3200 Problem Determination And Service Manual

10. If you are instructed to return the front USB connector assembly, follow all

Installing the front USB connector assembly

To install the front USB connector assembly, complete the following steps.
1. Carefully insert the front USB cable through the opening in the front of the
2. Squeeze the spring clips on the sides of the front USB connector assembly and
3. Place the bottom edge of the housing into the bottom of the opening in the
4. Reroute and connect the front USB cable to the system board (see
5. Install the upper bezel (see "Installing the upper bezel" on page 82).
6. Install the lower bezel (see "Installing the lower bezel" on page 80).
7. Install the side cover (see "Installing the side cover" on page 78).
8. Lock the side cover if it was unlocked during removal.
9. Reconnect the external cables and power cords; then, turn on the attached
2. Turn off the server and all attached devices; then, disconnect all power cords
and external cables.
3. Unlock and remove the side cover (see "Removing the side cover" on page
77).
4. Remove the lower bezel (see "Removing the lower bezel" on page 79).
5. Remove the upper bezel (see "Removing the upper bezel" on page 81).
6. Disconnect the front USB cable from the system board, noting the routing of
the cable (see "System-board internal connectors" on page 9 for the location of
the front USB connector).
7. Press down and hold the release tab on the top of the front USB housing;
then, tilt the top of the housing away from the chassis and lift the housing out
of the opening in the chassis.
8. Squeeze the spring clips on the sides of the front USB connector assembly
and pull the assembly out of the back of the housing.
9. Carefully pull the front USB cable out of the opening in the chassis.
packaging instructions, and use any packaging materials for shipping that are
supplied to you.
chassis.
insert the assembly into the housing through the back of the housing.
chassis; then, tilt the top of the housing into position until it clicks into place.
"System-board internal connectors" on page 9 for the location of the front USB
connector).
devices and turn on the server.
Chapter 4. Removing and replacing server components
115