Table of Contents
Advertisement
To remove the battery, complete the following steps:
58
IBM System x3610 Type 7942: Problem Determination and Service Guide
Statement 2:
CAUTION:
When replacing the lithium battery, use only IBM Part Number 33F8354 or
an equivalent type battery recommended by the manufacturer. If your
system has a module containing a lithium battery, replace it only with the
same module type made by the same manufacturer. The battery contains
lithium and can explode if not properly used, handled, or disposed of.
Do not:
– Throw or immerse into water
– Heat to more than 100°C (212°F)
– Repair or disassemble
Dispose of the battery as required by local ordinances or regulations.
1. Read the safety information that begins on page vii and "Installation guidelines"
on page 43.
2. Follow any special handling and installation instructions that come with the
battery.
3. Turn off the server and peripheral devices, and disconnect the power cord and
all external cables.
4. Pull the server out of the rack.
5. Remove the cover (see "Removing the cover" on page 46).
6. Disconnect any internal cables, as necessary.
7. Remove any adapters as necessary.
8. Locate the battery on the system board.
Advertisement
Table of Contents
