Installing The Front Usb Connector Assembly - IBM System x3100 M4 Type 2582 Problem Determination And Service Manual

11. Carefully pull the front USB cable out of the opening in the chassis.
12. If you are instructed to return the front USB connector assembly, follow all

Installing the front USB connector assembly

To install the front USB connector assembly on 4U server models with
non-hot-swap power supplies, complete the following steps. For the 5U server
model with hot-swap power supplies (Model name: 2582-F4x), please see the next
sub-section.
Front USB connector
assembly
packaging instructions, and use any packaging materials for shipping that are
supplied to you.
1. Read the safety information that begins on page vii and "Installation guidelines"
on page 163.
2. Turn off the server and all attached devices; then, disconnect all power cords
and external cables.
3. Remove the bezel (see "Removing the bezel" on page 169).
4. Carefully turn the server on its side so that it is lying flat, with the cover facing
up.
Attention: Do not allow the server to fall over.
5. Remove the side cover (see "Removing the side cover" on page 166).
6. Remove the air duct.
7. Carefully insert the front USB cable through the opening in the front of the
chassis.
Front USB housing
Chapter 5. Removing and replacing server components
Spring clips
233