JVC KW-M785BW Instruction Manual page 43

Settings Settings
<Serial Number>
Displays the serial number.
<Steering Remote Controller>
Assign functions to the keys on the remote controller
on the steering wheel.
• This function is available only when your car is
equipped with the electrical steering remote
controller.
• You can only register/change the functions while
you are parked.
• If your steering remote controller is not compatible,
learning may not be completed and an error
message may appear.
• For connection, see page 47 for more information.
1
Touch [SET] for <Steering Remote
Controller> to display the setting screen.
2
Press and hold a button on the steering
remote controller to register.
3
Select a function to assign to the selected
button.
Steering Remote Controller Setting
Performing Steering Wheel Remote Control Learning Process.
Press each of the buttons in sequential order.
VOL
VOL
ATT
SRC
Done
4
Repeat steps 2 and 3 to register other
buttons.
5
Touch [Done] to finish the procedure.
• The unit can register all of the buttons' functions at
the same time. To do this, press all buttons in turn
and after pressing all of them, touch [Done] on the
<Steering Remote Controller Setting> screen.
However, new functions cannot be learned after this
operation.
To change the previously assigned function:
1 Touch the key to change on the <Steering
Remote Controller Setting> screen.
2 Select a new function to assign from the function
list.
3 Touch [Done] to finish the procedure.
To initialize the setting: Touch [Initialize] for
<Steering Remote Controller>.
A confirmation message appears. Touch [Yes].
• To cancel the initialization, touch [No].
<System Information>
Update the system by connecting a USB device
containing an update file.
• To obtain the update file, visit
<https://www.jvc.net/cs/car/>.
Connect a USB device with the update file to the unit.
System Information
Application Version Vxxx
Update
System Version Vxxx Update
GNSS Version Vxxx
Update
Update starts. It may take a while. If the update has
been completed successfully, "Update Completed.
Please Ignition OFF" appears.
<Application Version>
Updates the system application.
<System Version>
Updates the system.
<GNSS Version>
Updates the Global Navigation Satellite firmware.
• Do not disconnect the USB device while updating.
• If the update has failed, turn the ignition switch off
then on, and retry the update.
ENGLISH 41