Install the 3.5-inch/2.5-inch drive cage
Use this information to install the 3.5-inch /2.5-inch drive cage.
About this task
To avoid potential danger, read and follow the following safety statements.
• S002
CAUTION:
The power-control button on the device and the power switch on the power supply do not turn off
the electrical current supplied to the device. The device also might have more than one power cord.
To remove all electrical current from the device, ensure that all power cords are disconnected from
the power source.
Attention:
• Read the
"Installation guidelines" on page 61
• Touch the static-protective package that contains the component to any unpainted metal surface on the
server; then, remove it from the package and place it on a static-protective surface.
Watch the procedure
A video of this procedure is available at YouTube:
DoEcxrm2zKNpaKOdZ3f8Qc
Procedure
Step 1.
Install the backplane or backplate (see
75
or
"Install the 3.5-inch simple-swap drive backplate" on page
Step 2.
Slide the drive cage in until the release latch clicks into place.
ThinkSystem ST250 V2 Setup Guide
74
to ensure that you work safely.
https://youtube.com/playlist?list=PLYV5R7hVcs-
.
"Install the 3.5-inch/2.5-inch hot-swap backplane" on page
76).