Bosch Climate 5000 Series Service Manual page 23

6.4.13 Louver position memory function
When turning on your unit, the louver will automatically resume its former angle.
6.4.14 46.4°F (8°C) heating (optional)
In heating mode, the temperature can be set to as low as 8°C, preventing the indoor
area from freezing if unoccupied during severe cold weather.
6.4.15 Active Clean function
The Active Clean Technology washes away dust, mold, and grease that may cause
odors when it adheres to the heat exchanger by automatically freezing and then
rapidly thawing the frost. The internal wind wheel then keeps operating to blow-dry
the evaporator, thus preventing the growth of mold and keeping the inside clean.
When this function is turned on, the indoor unit display window appears "CL",
after 20 to 45 minutes, the unit will turn off automatically and cancel Active Clean
function.
6.4.16 Follow me (optional)

If you press "Follow Me" on the remote, the indoor unit will beep. This
indicates the follow me function is active.

Once active, the remote control will send a signal every 3 minutes, with
no beeps. The unit automatically sets the temperature according to the
measurements from the remote control.

The unit will only change modes if the information from the remote control
makes it necessary, not from the unit's temperature setting.

If the unit does not receive a signal for 7 minutes or you press "Follow Me,"
the function turns off. The unit regulates temperature based on its own
sensor and settings.
6.4.17 Silence operation (optional)
Press "Silence" on the remote control to enable the SILENCE function. While this
function is active, the indoor unit will run at faint breeze(1% fan speed), which
reduces noise to the lowest possible level.
6.4.18 ECO intelligent (single zone only)
The system is controlled intelligently under Intelligent eye mode. It can detect the
people's activities in the room. In cooling/Heating/Auto mode, when you are away
for 30 minutes, the unit will automatically lower the frequency to save energy. And
the unit will automatically start and resume operation if sensing human activity
again.
6.4.19 Humidity control (single zone only)
The unit is able to increase the comfortable level by lowering humidity in your
home. The unit off ers a better temperature and humidity control solution in the
dry mode, the room temperature can be maintained accurately as set temperature
while the moisture is being removed.
Bosch Wall Mounted Ductless Split Air Conditioner / Heat Pump IDU-ODU - BTC 769102301 A (11.2022)
6.4.20 Electrical energy consumption control function (optional)
Press the "Gear" button on remote controller to enter the energy effi cient mode in a
sequence of following:
75% (up to 75% electrical energy consumption)
50% (up to 50% electrical energy consumption)
Previous setting mode
Turn off the unit or activate ECO, sleep, Super cool, 8°C Heating, Silence or self
clean function will quit this function.
6.4.21 Breeze away function (optional)
This feature avoids direct airfl ow blowing on the body and makes you feel indulging
in silky coolness.
This feature is available under cooling mode, fan-only mode and drying
mode.
6.4.22 Wireless control (optional)
Wireless control allows you to control your air conditioner using your mobile phone
and a wireless connection.
For the USB device access, replacement, maintenance operations must be carried
out by professional staff .
Service Manual
| 23