Configuration - Siemens LDS 6 Operating Instructions Manual

58 Date/Time
58 Date/Time Ch1 NH
New Date(dd-mm-yy;24h/day)
[01-04-04]
New Time (hh-mm; 24 h):
14:44
Set Clock
Actual Date Actual Time
01-04-2004 14:44
Note
Date and time must be reset in case of a power failure.
60 Setup Logbook
60 Setup Logbook Ch1 NH
Clear logbook
Lock logbook
4.3.6

Configuration

All functions of this block are only accessible via the password for level 2 except function 89 -
Ethernet On/Off which requires code level 3.
Input Menu
Configuration Ch1 NH
70 Analog Output
71 Relay Outputs
72 Binary Inputs
73 Communication
...Continue
LDS 6
Operating Instructions, 01/2022, A5E00295894-10
You can use this function to set the actual date and time.
The analyzer has a system clock which is not protected against power failure (not a real-
time clock). The clock is set at 01-01-00 00:00 when the analyzer is started.
3
This function allows you to exactly set the date and time. This is particularly important
when you need to assign a specific point in time to faults stored in the logbook. This can
be helpful when troubleshooting.
After selection of this function an editing field appears in which you can enter day, month
and year as "New date". Hours (24-hour system) and minutes are entered as "New time".
The set data are imported when you press the third soft key ("Set Clock"). The data then
appear as an active display at the bottom of the screen.
You can use this function to delete or lock logbook entries (see also function 3).
3
Following selection of the configuration functions in the main menu by pressing the fifth
soft key ("...Continue"), you can branch to the further configuration functions.
3
Operation
4.3 Analyzer functions
49