Raymarine AR200 Installation Instructions Manual page 23

1. Use the supplied Bracket mounting template (87170) to drill 3 pilot holes in the vertical mounting
surface. Secure the mounting bracket to the surface using the supplied screws.
2. Place the small sealing ring in the groove located on the bottom of the Mounting tray.
3. Secure the tray to the bracket using 3 of the supplied screws, in the positions indicated in the
illustration above.
4. Place the large sealing ring into the groove on the upper side of the Mounting tray.
5. Pull the SeaTalkng ® cable through the center of the bracket and tray. Plug in the cable connector
on the underside of the unit and secure by rotating the locking collar clockwise 2 clicks.
6. Insert the unit into the mounting tray, ensuring the tabs in the Mounting tray are slotted into the
grooves around the edge of the unit.
Important:
The unit must be mounted with the LED 'arrow' on the top of the unit pointing forwards, in parallel
alignment with the longitudinal axis (centerline) of your vessel.