Releasing The Unit From The Bracket - Raymarine AR200 Installation Instructions Manual

Releasing the unit from the bracket

Follow the steps below to release the unit from the Mounting bracket.
1. Insert the flat of a small flat blade screw driver, or similar tool into the release hole located on
the flat edge of the mounting bracket and twist the screw driver 90°, so that there is a small gap
between the Mounting trim and Mounting tray.
Important: To help prevent scratching the product, cover the tip of your screw driver with a small
piece of insulation tape.
2. With the screw driver in place, twist the mounting trim counter-clockwise approximately 10° and
then lift away from the unit.