3. Position the Mounting tray on top of the Riser.
4. Secure the Mounting tray to the Riser using 3x supplied fixings.
5. Place the large sealing ring into the groove on the upper side of the Mounting tray.
6. Pull the SeaTalkng ® cable through the Riser and Mounting tray. Plug in the cable connector on
the underside of the unit and secure by rotating the locking collar clockwise 2 clicks.
7. Insert the unit into the mounting tray, ensuring the tabs in the Mounting tray are slotted into the
grooves around the edge of the unit.
Important:
Unit orientation is not important with the RS150, but aesthetically the unit may look better with the
LED 'arrow' pointing towards the vessel's bow.
8. Place the Mounting trim over the unit slightly offset, and then twist the Mounting trim clockwise
until it locks into position.