Table of Contents
Advertisement
Displayed only when an
exposure value other
than 0 is selected.
Control panel
5
Press the
The green highlight returns to the flash
control mark
When any value other than zero (0) is
selected, the flash control mark
displayed in the control panel. Please
remember that this setting is retained even
after the camera is switched off and
5
switched on again.
To release this setting, reset the value for
zero.
Press the
menu.
6
Take the picture.
To use the dedicated external flash
and built-in flash together
When the dedicated external flash is mounted
on the camera, the camera automatically sets
the flash for TTL-AUTO. With this setting, the
camera can adjust the intensity of the flash fired
from the dedicated flash, just as it automatically
adjusts the flash intensity for the built-in flash. If
you set the dedicated flash for MANUAL, this
disables automatic adjustment of the flash
intensity only for the dedicated external flash;
the intensity of the built-in flash will continue to
be controlled by the camera.
button.
and the setting is stored.
is
button again to close the
6
95
Advertisement
Table of Contents
