Table of Contents
Advertisement
1
Flash working range
ISO
Max. WIDE (WIDE Limit)
AUTO
0.6 (2 ft.) - 8.9 m (29.4 ft.)
80
0.6 (2 ft.) - 6.3 m (20.8 ft.)
160
0.9*
1
(3 ft.) - 8.9 m (29.4 ft.)
1
320
1.3*
(4.3 ft.) - 12.5 m (41.3 ft.)
Range starts at 0.6 m (2 ft.) if you set the camera to the A (Aperture Priority) mode and stop the
*
1
aperture size down to 6.3 or higher.
Range starts at 0.5 m (1.7 ft.) if you set the camera to the A (Aperture Priority) mode and stop
2
*
the aperture size down to 6.3 or higher.
If you attempt to use the flash closer than the ranges described above, the entire picture may be too
bright, or shadows may appear in parts of the picture. If you attempt to use the flash farther than the
ranges described above, the light from the flash will not reach the subject and the subject will
appear dark. You may be able to take a picture farther than these ranges by increasing the ISO
value, but raising the ISO value could cause the picture to appear grainy. With ISO set for AUTO, the
ISO value will be adjusted automatically within the range of 80 - 160. (© 88)
2
Max. TELE (TELE Limit)
0.5 (1.7 ft.) - 7.4 m (24.4 ft.)
0.5 (1.7 ft.) - 5.2 m (17.2 ft.)
0.7*
2
2
1.0*
1
Press the flash button
The built-in flash opens.
If the built-in flash is not raised, the flash
mode remains set at OFF and cannot be
changed.
2
Press and hold down the flash
mode button
main dial or the sub dial. Continue
to turn the dial until you see the
desired combination of flash
control setting marks, and then
stop turning the dial.
3
Take the picture.
(2.3 ft.) - 7.4 m (24.4 ft.)
(3.3 ft.) - 10.4 m (34.3 ft.)
When the flash is not required
When you do not want to use the flash, for
example when photographing subjects as a
sunset or night scene, shooting a subject that
the flash will not reach, or shooting a subject in
a location where flash photography is not
allowed (such as in a museum), just press down
the built-in flash to close it. If an external flash
unit is connected to the camera, switch it off or
remove it. (Some external flash units may
require removal and others may not; you can
just switch them off.)
.
, and then turn the
93
6
Advertisement
Table of Contents
