Table of Contents
Advertisement
Camera does not operate when you press the shutter button?
Problem
Is "0" and the
mark blinking in the control
panel?
Is the battery check mark
control panel?
The memory gauge
control panel.
(The number of blinking memory gauge bars
varies depending on the camera settings.)
Is the flash mark
blinking in the
viewfinder?
Is the mode dial set for playback
reserve mode
, or setup/connection mode
?
Is a card inserted in the camera?
Is a protect seal attached to the card?
The card is full. Replace the card with a fresh
card, or you can delete unneeded images on the
card to create more storage space on the card,
or you can transfer all the images to a computer,
and then delete all the images, or format the
card.
If folder numbering has reached 999, or if file
numbering has reached 9999, you will not be
able to continue shooting pictures with the card,
even if it is not full. Transfer all images to a
computer, and then delete all images from the
card.
blinking in the
Replace the batteries. Check the card
access lamp. If the card access lamp is
blinking, wait for it to stop blinking before you
remove the batteries.
If the memory gauge is blinking, which
is blinking in the
indicates the buffer full, you cannot continue
shooting. Wait until the data in the buffer is
transferred to the card and the memory
gauge stops blinking.
The built-in flash is recharging. Wait for the
flash mark to light and then remain on before
you resume shooting with the flash.
Set the mode dial to P, A, S, or M.
, print
Insert a card in the camera.
Remove the card and then remove the
protect seal, or insert a new card.
Solution
Page
© 32
© 29
© 38
© 42
© 70
© 24
© 24
193
Advertisement
Table of Contents
