Table of Contents
Advertisement
Built-in flash does not fire.
Problem
Is the built-in flash raised?
Is the subject brightly lit?
Monitor difficult to see.
Problem
Monitor dark?
Sunlight striking the monitor?
Cannot transfer data to computer.
Problem
Is the cable connected securely?
Something other than lines displayed in the
control panel? Cannot operate the camera?
Is the USB driver correctly installed?
Solution
Press the flash button
unit.
If there is sufficient incident light, the flash
will not fire. If you must use the flash, use the
fill-in flash mode.
Solution
Adjust the monitor brightness.
Use your hand to block the glare from
sunlight so you can see the monitor.
Solution
Check the connection at the camera and
computer and make sure the connections
are tight.
See "Cannot operate the camera, monitor
and control panel blank."
If your operating system is Windows 98/98SE,
install the USB driver following the instructions
in the "Software Installation Guide."
Page
© 42
to raise the flash
© 91
Page
© 150
−
Page
© 176
© 192
© 176
195
Advertisement
Table of Contents
