Table of Contents
Advertisement
Control panel
Sequential mode
Sequential mode selected
automatically when
autobracketing is selected.
Note
• After the camera is set for auto bracketing, one of the following actions will release the camera
from auto bracketing and set it to the burst mode:
- When the mode dial is set to M (Manual mode).
- When the flash button is pressed and the built-in flash is raised.
- When the dedicated external flash FL-40 is mounted.
• The mode dial setting determines which features are changed during autobracketing.
P
Program mode. Shutter speed and aperture value adjusted.
A Aperture priority mode. Shutter speed adjusted.
S
Shutter priority mode. Apeture adjusted.
• The shutter speed and aperture value display the adjusted exposure.
• If autobracketing (
are calculated for both during shooting with autobracketing.
• If the camera is switched off suddenly during autobracket shooting, the camera will finish the
autobracketing shooting sequence after the camera is switched on again.
• Autobracketing will halt as soon as you release your finger from the shutter button and resume
shooting the remaining pictures after you press the shutter button again.
• With the camera set in autobracketing, you cannot select the self-timer mark
control mark . To select these marks, release the camera from autobracketing with the menu.
• If you select autobracketing while the self-timer mode or the remote control mode is set, both
modes will be automatically released.
7
Autobracket
setting mark
86) and exposure compensation (
7
Press the
This completes setting the camera for
autobracketing. In the control panel, you
will see BKT and the sequential mode
mark
displayed. This confirms that the
camera is set for both autobracketing and
shooting multiple exposures. (When
shooting in the single-frame mode, hold
down the drive button
main dial or sub dial until you do not see
the sequential mode mark
the control panel.)
Press the
button again to close the
menu.
8
Take the picture.
When the camera is set in the sequential
mode, press the shutter button once to
shoot three rapid pictures with the
exposure setting varied automatically for
each shot.
When the camera is set in the single-
frame shooting mode, you must press the
button once to take each picture with the
exposure setting varied automatically for
each shot.
84) are selected together, then values
button.
and turn the
displayed in
, or the remote
5
87
Advertisement
Table of Contents
