Mitsubishi Electric PUMY-P36NKMU3 Technical & Service Manual page 147

OPERATING PROCEDURE
13. Removing the compressor (MC)
(1) Remove the service panel. (See Photo 1)
(2) Remove the top panel. (See Photo 1)
(3) Remove the cover panel (front). (Refer to procedure 8(5))
(4) Remove the cover panel (rear) (Refer to procedure 8(6))
(5) Remove the side panel (R). (Refer to procedure 8 (7))
(6) Remove 2 front cover panel fixing screws (5 × 12) and
remove the front cover panel. (See Photo 4)
(7) Remove the electrical parts box. (See Photo 5)
(8) Remove the valve bed. (Refer to procedure 8 (4))
(9) Remove 3 separator fixing screws (4 × 10) and remove
the separator. (See Figure 2)
(10) Recover refrigerant.
(11) Remove the 3 compressor fixing nuts for motor using
spanner or adjustable wrench.
(12) Remove the welded pipe of compressor inlet and outlet
and then remove the compressor.
Note: Recover refrigerant without spreading it in the air.
Figure 2
Separator
fixing screw
OCH733
Photo 13
Valve bed
Valve bed
fixing screw
Front cover
panel fixing
screws
Photo 14
Compressor
(MC)
Separator
fixing
screws
Separator
Separator
fixing screw
147
PHOTOS/FIGURES
Compressor
fixing nuts
Valve bed
fixing screws
Right side
panel
Rear cover
panel fixing
screws
Accumulator
Accumulator
leg
Accumulator
leg fixing
screws