Gps Internal Antenna; Nmea 2000 Cable Connections; Connecting To A Nmea 2000 Network - Lowrance GlobalMap 3600C iGPS Operation Instructions Manual

Mapping gps receiver
Hide thumbs Also See for GlobalMap 3600C iGPS:
Table of Contents

Advertisement

WARNING:
This product must be independently fused with the en-
closed 3-amp fuse (or equivalent), even if you connect to
a fused accessory or power buss.
If a malfunction happens inside the unit, extensive dam-
age can occur if the enclosed fuse is not used. As with all
electrical devices, this unit could be damaged to a point
that it is unrepairable and could even cause harm to the
user when not properly fused.
CAUTION:
Do not use this product without a 3-amp fuse wired into the power
cables! Failure to use a 3-amp fuse will void your warranty.
This unit has reverse polarity protection. No damage will occur if the
power wires are reversed. However, the unit will not work until the
wires are attached correctly.

GPS Internal Antenna

This unit has a built-in 12-parallel channel GPS + WAAS antenna.

NMEA 2000 Cable Connections

NMEA 2000 is a new buss network specifically designed for boats. This is
a very young industry standard and, at the time of printing, few boats
being built now have a NMEA 2000 buss installed. Over the next few
years, however, NMEA 2000 will become much more common. To help
you get the most out of this technology, your Lowrance unit is designed
to work with a NMEA 2000 network. You can install a network yourself
using LowranceNET components and devices.
To NMEA 2000
network port
Lowrance unit direct connection to NMEA 2000 buss.

Connecting to a NMEA 2000 Network

Your unit can be connected to a NMEA 2000 buss, receiving sensor infor-
mation from any Lowrance units attached to the buss. Contact LEI Extras
(look inside back cover for accessory ordering information) for a NMEA
2000 buss adapter cable if you would like to do this. You can connect the
unit directly to a network port. To do so, attach the adapter cable's manual
locking collar connector to the Network port on the back of the GPS unit
and attach the other end to an available port on the NMEA 2000 buss. As
soon as the unit is connected to the network, it will begin receiving
14
To unit's
Network
socket

Advertisement

Table of Contents
loading

Table of Contents