Table of Contents
Advertisement
Wake-up System with Dynamic Time
Use this item to enable or disable System wake on alarm event.
System will wake on the current time + Increase minute(s).
The optional settings: [Disabled]; [Enabled].
When set as [Enabled], system will wake on the current time + increased minute(s).
USB/PS2 Power Gating in S4-S5
Use this item to enable or disable USB/PS2 wake-up from S4-S5.
USB Wake-up is affected by ERP function in S4. Please disable ERP before activating
this function in S4.
The optional settings: [Disabled]; [Enabled].
This function is supported when 'ERP Support' is set as [Disabled].
*Note:
USB Configuration
Press [Enter] to make settings for the following sub-items:
USB Configuration
Legacy USB Support
Use this item to enable or disable Legacy USB support.
The optional settings are: [Enabled]; [Disabled]; [Auto].
[Enabled]: To enable legacy USB support.
[Disabled]: To keep USB devices available only for EFI specification,
[Auto]: To disable legacy support if no USB devices are connected.
XHCI Hand-off
This is a workaround for OSes without XHCI hand-off support. The XHCI ownership
change should be claimed by XHCI driver.
The optional settings are: [Enabled]; [Disabled].
USB Mass Storage Driver Support
Use this item to enable or disable USB Mass Storage Driver Support.
The optional settings are: [Disabled]; [Enabled].
USB Hardware Delays and Time-outs:
USB Transfer Time-out
Use this item to set the time-out value for control, bulk, and interrupt transfers.
The optional settings are: [1 sec]; [5 sec]; [10 sec]; [20 sec].
Device Reset Time-out
Use this item to set USB mass storage device start unit command time-out.
The optional settings are: [10 sec]; [20 sec]; [30 sec]; [40 sec].
41
Advertisement
Table of Contents
