JETWAY MI12-00V Series User Manual page 43

Console Redirection
Use this item to enable or disable Console Redirection.
The optional settings: [Disabled]; [Enabled].
When set as [Enabled], the following sub-items shall appear:

Console Redirection Settings
The settings specify how the host computer and the remote computer (which the user
is using) will exchange data. Both computers should have the same or compatible
settings.
Press [Enter] to make settings for the following items:
Out-of-Band Mgmt Port
The default setting is: [COM1].
Terminal Type
The optional settings: [VT100]; [VT100+]; [VT-UTF8]; [ANSI].
[VT-UTF8] is the preferred terminal type for out-of-band management. The next best
choice is [VT100+] and them [VT100]. See above, in Console Redirection Settings
page, for more help with Terminal Type/Emulation.
Bits per second
Use this item to select serial port transmission speed. The speed must be matched on
the other side. Long or noisy lines may require lower speeds.
The optional settings: [9600]; [19200]; [57600]; [115200].
Flow Control
Flow control can prevent data loss from buffer overflow. When sending data, if the
receiving buffers are full, a "stop" signal can be sent to stop the data flow. Once the
buffers are empty, a "start" signal can be sent to re-start the flow. Hardware flow control
uses two wires to send start/stop signals.
The optional settings: [None]; [Hardware RTS/CTS]; [Software Xon/Xoff].
Data Bits
The default setting is: [8].
*This item may or may not show up, depending on different configuration.
Parity
The default setting is: [None].
*This item may or may not show up, depending on different configuration.
Stop Bits
The default setting is: [1].
*This item may or may not show up, depending on different configuration.
37