Table of Contents
Advertisement
WatchDog Wake-up Timer Unit
The optional settings are: [Sec.]; [Min.].
ATX Power Emulate AT Power
This item support Emulate AT power function, MB power On/Off control by power supply.
Use needs to select 'AT or ATX Mode' on MB jumper at first (refer to Page 11 , jumper
ATX_AT pin 1-2 for ATX Mode & pin 2-3 for AT Mode Select).
Serial Port Console Redirection
COM1
Console Redirection
Use this item to enable or disable Console Redirection.
The optional settings: [Disabled]; [Enabled].
When set as [Enabled], the following sub-items shall appear:
Console Redirection Settings
The settings specify how the host computer and the remote computer (which the user
is using) will exchange data. Both computers should have the same or compatible
settings.
Press [Enter] to make settings for the following items:
Terminal Type
The optional settings: [VT100]; [VT100+]; [VT-UTF8]; [ANSI].
Emulation: [ANSI]: Extended ASCII char set; [VT100]: ASCII char set; [VT100+]:
Extends VT100 to support color, function keys, etc.; [VT-UTF8]: Uses UTF8 encoding
to map Unicode chars onto 1 or more bytes.
Bits per second
Use this item to select serial port transmission speed. The speed must be matched on
the other side. Long or noisy lines may require lower speeds.
The optional settings: [9600]; [19200]; [38400]; [57600]; [115200].
Data Bits
The optional settings: [7]; [8].
Parity
A parity bit can be sent with the data bits to detect some transmission errors.
The optional settings: [None]; [Even]; [Odd]; [Mark]; [Space].
[Even]: parity bit is 0 if the num of 1's in the data bits is even; [Odd]: parity bit is 0 if
num of 1's in the data bits is odd; [Mark]: parity bit is always 1; [Space]: Parity bit is
always 0; [Mark] and [Space] Parity do not allow for error detection.
35
Advertisement
Table of Contents
