Getting Started - Lorex DHT304 Installation & User Manual

GETTING STARTED :

1. Connect the AC Power Cord to the Power Adapter and plug into an electrical outlet.
Connect up to 4 cameras to the BNC Video inputs on the back of the DVR.
Turn the Main Power Switch to ON.
The Red LED indicator will illuminate and the DVR will be in the standby mode
2. A following message appears when power is ON successfully.
POWER ON CHECK _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _
HDD IDENTIFY CHECK _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ OK
HDD R/W CHECK _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ OK
MODEL
HDD LBA
HDD SPACE : XXX GB
Note : The system is only checking for a MASTER HDD. Install Slave HDD onto DVR in case
using Slave HDD and set at HDD Slave in SETUP MENU.
Note : HDD is not properly connected if FAIL message shows.
Retry connecting HDD and turn on the power.
MAC ADDRESS : XX XX XX XX XX XX
IP ADDRESS
SUBNET MASK : 255 . 255 . 255 . 000
GATEWAY
PORT
Note : Above message indicates set network value in DVR
Note : Set Network values can be changed in SETUP MENU.
*** MASTER HDD DETECT ***
: XXXXXXXXXXXXXXXXXXXXXX
: XXXXXXXXXXXXXXXXXXXXXX
*** NETWORK INFOMATION ***
: 192 . 168 . 001 . 100
: 192 . 168 . 001 . 001
: 5555
- 05 -
OK
100 %