Lorex DHT304 Installation & User Manual page 25

(vii) HDD OVERWRITE : Select [Y] to have the DVR automatically overwrite previously recorded
Note : HDD Overwrite replaces the earliest recorded video with additional video being recorded.
When the HDD is Full and Overwrite is active, the first piece of video that you recorded will be
lost.
(viii) HDD SLAVE : Select [Y] to enable the system to check for a Slave HDD upon startup.
Enabling HDD SLAVE allows you to record to and playback from the Slave HDD.
Note : After activating the Slave HDD, you need to restart your system by turning the Main Power
Switch (located on the back of the monitor) OFF and then ON again in order for the system to
recognize the Slave HDD.
9. ALARM REC SET - This submenu allows you to configure the Recording parameters under the
(i) ALARM REC : This setting selects whether or not the DVR will record automatically when a Motion
(ii) PRE ALARM REC : Selects the enable or disable of "PRE ALARM".
Note : PRE ALARM saves 6secs of image at 5ips before ALARM or MOTION goes off under
alarm or motion situation. (When ALARM REC mode is on, images are being stored in
HDD.)
(iii) REC QUALITY : Selects the Recording Quality level for Alarm Recording (from Normal, High, or
(iv) REC SPEED : Sets the speed of Alarm Recording from 60 / 30 / 15 / 10 / 08 / 04 / 02 / 01 IPS.
(v) REC DURATION : Selects how long the DVR will automatically record after an alarm is triggered.
10. SCHEDULE REC SET - This Submenu allows you to Schedule times in which you're programming
(i) SCHEDULE REC : Select from the following types of Scheduled recordings:
[DAILY] - Recording will be carried out according to a specified time on a daily schedule.
[OFF] - No schedule.
[ONCE] - Recording will be carried out one time, according to the schedule.
(ii) N0-N7 : Total 8 REC can be set up from N0 to N7.
Each Schedule Rec can control Start TIME/DATE, End TIME/DATE and Rec Quality as
well as Rec Speed can be set up in this mode..
Note : When SCHEDULE REC is set up, the recording time should not be overlapped from one
scheduled recording to another. If it is overlapping this will result in a loss in recorded
activity and the schedule may be ignored.
To delete a scheduled recording, place the cursor on the selected time and press the ◀, ▶ key.
"CURRENT LINE DELETE? [Y] / [N]" is then displayed. If [Y] is selected, the selected schedule is
is deleted.
video in the event of the HDD becoming FULL. If you select "Y" it will display
OVWR (Overwrite) in the on-screen display. If you select "N", the DVR will
terminate recording once it reaches its capacity.
Alarm condition.
Detection or a PIR alarm is triggered.
Best).
Available duration times are: [ 20SEC / 30SEC / 1MIN / 2MIN / 5MIN and
CONTIN]
CONTIN refers to Continuous recording.
the DVR to record automatically.
- 21 -