Lorex DHT304 Installation & User Manual page 23

5. MOTION SET - This submenu allows you to enable / disable the Pixel-based Motion Detection
function by channel and set its Sensitivity level.
(i) MOTION : Selecting [OFF] disables the Pixel-based Motion Detection function. Selecting [OSD]
will allow motion to trigger alarms, and the letters "MD" will appear on the screen of the
camera location where the motion is taking place. A third option, [OSD+BUZZER] will
display "MD" and emit a buzzer sound in the event that motion is detected.
(ii) CHANNEL : Select which channels will have the Pixel Motion Sensing feature activated.
The Sensitivity level can be set to zero for a channel, which will disable the Motion
Sensing ability for that channel.
(iii) SENSITIVITY : Select the level of the Motion Sensing's sensitivity level by channel.
(iv) AREA : Select the area of the screen where the Pixel Motion Sensing feature will be active.
The digits below represent the area on the screen where motion is detected.
[ 00 ] - Whole screen.
[ 02 ] - Top right side of screen.
[ 04 ] - Bottom right side of screen.
6. SYSTEM SET ( l ) -This sub-menu allows you to configure various preferences on the system, related
(i) KEY BUZZER : When set to [Y], the system will make a sound when a key is pressed on the
(ii) LOSS BUZZER : When set to [Y], the system will make a sound when a camera becomes
(iii) QUAD LINE : Activates and deactivates the border line in Quad mode.
(iv) BLANK COLOR : Choose between blue, gray or black as the background screen color in Menu
(v) TITLE/TIME : Change the location of on-screen display for Time/Date and camera titles. T/R/B/L
represent Top / Right / Bottom / Left respectively. Therefore, for example, the
setting "TR/BL" would display the Title in the Top-Right corner of the screen, and the
Time in the Bottom Left corner.
(vi) PAN/TILT(CH1) : Activates Pan/Tilt mode to become accessible.
(vii) ALARM OUT : Select the Alarm Out setting, which is defaulted to NO (Normally Open) for
(viii) DEFAULT SET : Selecting [Y] resets all programmed settings back to the default factory
7. SYSTEM SET ( ll ) - This sub-menu allows you to configure various preferences on the system,
Level 05 is the highest sensitivity, Level 01 is the least sensitive.
Level 00 deactivates Motion Sensing.
00
to Monitor settings.
remote control or on the main panel of the monitor.
disconnected.
Mode.
triggering external devices.
settings (except for the time & date).
related to DVR settings.
[ 01 ] - Top left side of screen.
[ 03 ] - Bottom left side of screen.
[ 05 ] - Center of the screen.
01 02
03 04
- 19 -
05