Lorex DHT304 Installation & User Manual page 22

Enter the MENU screen by pressing the Setup button. Scroll through the 11 options by pressing the UP
and DOWN buttons. To enter a sub-menu, press the Enter button where the highlighted scroll bar is
located. To exit the Main Menu, scroll down to the Exit option and press the Enter button.
Note : In sub menu of the Main Menu, you can exit the Menu mode by selecting Exit, or you can return
to the Main Menu by selecting Return.
Note : The Menu is exited automatically after 20 sec of inactivity.
1. TIME / DATE SET - This submenu allows you to change the Time and Date displayed on the monitor,
(i) DISPLAY : Selecting [Y] enables on screen display of the date & time.
Selecting [N] hides this information.
(iii) TIME : Change the time (24 hour clock)
(iv) DATE : Change the date.
(v) DATE FORMAT : There are three formats to display the date:
2. SEQUENCE SET - This submenu allows you to select how long you'd like each channel to appear
Note : Channels without a camera, a Video Loss, or a Dwell Time of zero will be skipped in
sequencing.
3. TITLE SET - This submenu allows you to change the title of each camera location (up to 8 characters),
or remove the titles from the on-screen display.
(i) DISPLAY : Selecting [Y] will enable the camera titles to appear in the on-screen display. Selecting
[N] will remove all titles from appearing in the on-screen display.
(ii) CH 1 - 4 : Change the titles of each individual camera.
4. ALARM SET - This submenu allows you to enable / disable the camera's PIR Alarm function by
channel.
(i) ALARM : Selecting [OFF] disables PIR motion detection from triggering any alarm.
Selecting [OSD] will allow alarms to be triggered, and the letters "AL" will appear on the
screen of the camera location where the alarm is taking place. A third option,
[OSD+BUZZER] will both display "AL" and emit a buzzer sound in the event of an alarm.
(ii) CH 1-4 : Set the length of alarm time for each channel between 1~59 seconds. Additionally, you
can select the Alarm Input. The default setting is OFF - to activate the Alarm on a
camera, change the setting to N/O (Normally Open), N/C (Normally Close).
Note : Some alternative brand PIR motion sensors have a default setting of N.C (normally closed).
In order to activate the alarm on such a PIR motion sensor, change the setting to N.C
and also program the information you'd like to appear in the On-Screen Display.
MM / DD / YYYY : for U.S.A.
YYYY / MM / DD : for Asian countries.
DD / MM / YYYY : for European countries.
on-screen before automatically switching to the next channel in Sequence mode.
The Dwell Time is 0-59 seconds selectable for each of the 4 channels and for
Quad mode.
- 18 -