Table of Contents
Advertisement
3. Connect the HDD into the Cartridge Casing
Take the Hard Disk Drive and Connect the two cables from the back of the Cartridge
Casing to the HDD. The cables should be pushed in firmly, but not forcibly.
The 4 Pin connection is the DC Power cable, and the wider cable is the
standard Hard Drive IDE type connection.
4. Secure the HDD in the Casing (optional)
Use screws and tighten them, positioning the HDD into place. This step is optional, but it is
recommended.
5. Slide the top Cover over the Cartridge Casing
Slide the Cover forward over the Cartridge Case. Ensure it is secured in place over the
release latch.
6. Reinsert the Cartridge Casing into the DVR
Fully insert the Cartridge Case into the DVR.
- 35 -
Advertisement
Table of Contents
