Lorex DHT304 Installation & User Manual page 13

4. POP BUTTON
POP divides the screen into 4 screens, with the main channel occupying two-thirds of the screen.
To swap the positions of cameras appearing in POP ( Between the Main and Sub screen ), press this
button. To exit POP mode, press the other button.
5. SEQ BUTTON
Used to sequence between all camera locations in full screen in sequential order with the screen
automatically switching. Press SEQ again to stop sequential viewing. Sequence settings are
programmable via the Menu.
6. SETUP BUTTON
This button performs two functions:
a) A-SEL : In Quad mode, you can select the channel with audio. Pressing this button automatically
changes the audio from channel to channel. An audio microphone symbol will appear in the
corner of a Quad screen to indicate audio is available on a particular channel.
b) MENU : Holding this button for 3 seconds brings up the Main Menu.
7. EVENT BUTTON
Pressing this button brings up a list of up to 3000 Events, including Power, Loss and Alarms.
You can scroll through Events using the ▲ and ▼ keys, and navigate between Pages of Events using
the ◄ and ► keys. Press QUAD / ENTER Button to exit the Event list.
The following letters represent the different types of Events that you may find listed:
P : Shows the time when the POWER was turned ON
A : Shows the time when a PIR ALARM was triggered
M : Shows the time when Pixel-based MOTION detection was triggered
L : Shows when a Video LOSS from a Camera occurred
N : Starting time of storing data with Manual recording.
H : Time of problem occurring in HDD.
8. SEARCH BUTTON
Pressing this button brings up the Search menu, which allows you to quickly find recordings.
9. PTZ / ALRS BUTTON
a) PTZ : This button activates the Pan/Tilt feature.
b) ALRS : During an Alarm, this button will turn off the alarm sound and set the system to the previous
setting.
MAIN
SUB SUB SUB
POP
- 09 -