Listening To Radio - Jensen JBS-500 User Manual

Bluetooth cd music system with digital fm stereo receiver and remote control

Hide thumbs

Table Of Contents

Table of Contents

Note: The SNOOZE feature is only active for 60 minutes after the original alarm time.

You can press SNOOZE button again multiple times as long as it's within that 60 minutes

active period, and as long as a minimum of 10 minutes remain. Once the 60 minutes

expires, the alarm will stop until next day.

POWER/STANDBY Button on main unit or remote control to turn on the

1. Tap the

unit.

2. Tap the MODE Button on main unit or remote control to select FM mode. The FM

frequency appear in display.

3. To manual tune to a specific radio station, tap the

remote control repeatedly. Use the manual tuning method to tune in weaker stations

that are bypassed during automatic tuning.

4. To automatically tune to the next available radio station, press and hold

on main unit or remote control for 1-2 seconds until frequency readout on the display

begins to scan and then release the button. The tuner will stop scanning when it

receives the next broadcasting station of adequate signal strength.

5. Rotate the VOLUME knob on main unit or press the VOLUME

remote control to adjust the volume control to the desired volume level.

FM/ FM Stereo reception

When listening to the FM radio, press the

switch between stereo mode (ST) and mono mode (MONO). It is preferable to receive the

program in mono when you are receiving a weak station.

HINTS FOR BEST RECEPTION:

For best FM reception, the FM lead wire antenna located on the back of the unit should be

fully unwrapped and extended.

NOTE: Automatic tuning depends on the signal strength of the broadcasting station, so

weak stations may be skipped. You can manually tune to find the weak stations if a station

gets skipped. With strong signals, the tuner may stop before it reaches the actual

broadcast frequency, so you may need to manually tune for the best reception.

PRESET RADIO STATIONS

POWER/STANDBY Button on main unit or remote control to turn on the unit.

1. Tap the

2. Tap the MODE Button on main unit or remote control to select FM mode.

3. Press and hold

search and program preset channels. "PROG" appears in display and flashing. Auto

searching and programming will stop at PROG 01 after scan finished, "PROG" shows in

display steadily.

Note: If the channels stored during the auto search but programmed preset are not your

favorites, use the method below for the manually saving radio presets.

4. Tune to the desired radio station either by "manually" or "automatically" tuning method.