Jensen JBS-500 User Manual page 10

Remote Control
The remote control operates 2 x 1.5V AAA size batteries
(included). If the remote operation becomes intermittent or
unsatisfactory, replace the original batteries with new
batteries.
1.) Open the battery compartment cover.
2.) Insert two "AAA" (UM-4) batteries (included) and observe
the polarity as indicated inside the battery compartment
when installing.
3.) Replace the cover.
CAUTION:
1.) Danger of explosion if the battery is replaced incorrectly.
2.) Replace only with the same or equivalent type battery.
NOTE: Only use a well-known brand of batteries to
ensure the longest life and best performance.
Battery Precautions
⚫
Replacement of batteries must be done by an adult.
⚫
Do not mix old and new batteries.
⚫
Do not mix alkaline, standard (carbon-zinc) or rechargeable (nickel-
cadmium) batteries.
⚫
If the batteries in the device have expired or the device is not to be
used for a long period of time, remove the battery to prevent damage or
injury from possible battery leakage.
⚫
The supply terminals are not to be short-circuited.
⚫
Non-rechargeable batteries are not to be recharged.
⚫
Exhausted batteries are to be removed.
⚫
Only batteries of the equivalent type are to be used.
⚫
Batteries are to be inserted with the correct polarity.
⚫
Dispose of batteries properly. Do not dispose of batteries in fire or leave
in direct sunlight. The batteries may explode or leak.
⚫
Clean the contacts of the batteries and the contacts in the device prior
to battery installation.
E-9