Listening To Radio - Jensen MCR-1000 User Manual

BATTERY NOTE AND CARE
1. Danger of explosion if the battery is replaced incorrectly. Replace only with the same or
equivalent type
2. Do not mix old and new batteries.
3. Do not mix alkaline, standard (carbon-zinc) or rechargeable (nickel-cadmium) batteries.
4. If the unit is not to be used for an extended period of time, remove the batteries. Old or leaking
batteries can cause damage to the unit and may void the warranty.
5. Do not try to recharge batteries not intended to be recharged; they can overheat and rupture.
(Follow battery manufacturer's directions).
6. Do not dispose of batteries in fire, batteries may leak or explode.
BATTERY REPLACEMENT
When the output sound of this unit becomes distorted or the CD player operation appears unstable,
the batteries are weak. You need to replace all the exhausted batteries at the same time as soon
as possible to avoid battery leakage.
1. Slide the FUNCTION SWITCH to RADIO position.
2. Slide the AM/FM switch to select band.
3. Rotate the TUNING CONTROL KNOB to your desired radio station according to the DIAL
SCALE on the knob.
4. Rotate the VOLUME CONTROL KNOB to adjust to the desired volume level.
To turn off the radio, slide the FUNCTION SWITCH to the "TAPE/OFF" position.
5.
TIPS FOR BEST RECEPTION
AM – The AM antenna is located inside the cabinet of the unit. If AM reception is weak, change the
position of unit until the internal antenna picks up the strongest signal.
FM – If a stereo broadcast program is received, the unit will automatically switch to stereo mode
and you will hear the stereo broadcast. Always keep the FM TELESCOPIC ANTENNA fully
extended for best performance. If the FM reception is weak, try adjusting the antenna or try
repositioning the unit near a window until you get the best reception.
PLEASE READ THIS IMPORTANT INFORMATION:
The CD mechanism used in devices like this are designed to fully read all commercial CDs. They
will also read self-compiled CD-R/CD-RW and MP3 CD discs, but it may take up to 10 seconds for
playback to start. If playback does not start, it is likely due to the quality of the CD-R/RW disc
and/or the compatibility of the CD compilation software. The manufacturer is not responsible for
the playback quality of CD-R/RW discs.
Do not attach a label or seal to either side of CD-R/CD-RW and MP3 CD discs you make yourself.
It may cause a malfunction.
PLAYING A CD
Slide the FUNCTION SWITCH to the "CD" position.
1.
2. Press the CD door EJECT button to open the CD DOOR, load a CD with the label side facing
outward and then close the CD door.
3. Disc information (total number of tracks) will appear on the LCD DISPLAY.
4. Press the PLAY/PAUSE
" " will light steadily.
5. While playing, press the PLAY/PAUSE
" " will flash. Press PLAY/PAUSE
6. Adjust the VOLUME CONTROL KNOB to the desired volume level.
7. Press STOP BUTTON to stop playing.
To turn off the unit, slide the FUNCTION SWITCH to "TAPE/OFF" position.
8.

LISTENING TO RADIO

CD OPERATION
BUTTON to start playing the CD, the PLAY/PAUSE INDICATOR
BUTTON to pause, the PLAY/PAUSE INDICATOR
BUTTON again to resume playing.
E-9